COUNTERBALANCE FLOOR CRANES

                               

                     


COUNTERBALANCE FLOOR CRANES are manufactured to the highest quality standards and all are fully transportable/portable cranes.

The Counterbalanced crane design allows the operator freedom to work very close to machines or over obstructions that would not be possible with traditional floor cranes that use front stabilizing forward facing legs for stability.

OPERATION OF CRANES:

Although adequate care has been taken while designing the crane and various safety Features provided, the overall safety and maintenance of cranes depends to a large extent on the skill of the operator.

A trained and efficient operator could contribute to a large extent in reducing maintenance cost and prolong the life of the crane by skilful manipulation of the controls allowing the motors to accelerate gradually to avoid heavy impacts and prevent high current draw The operator shall avoid swinging the loads and shall coase the crane to stop rather than causing sudden stopping of the motor and hard braking which result in Skidding of brakes.

Therefore, it is absolutely essential that operator is given proper training in handing the crane and is duly certified by a qualified person before he is permitted to handle the crane independently t may be ensured that no one should be in the cab with the crane operator except when under training or on maintenance duties Likewise, no person shall be on the bridge walkway or on the trolley during normal operation. 12 Operating Procedure

FEATURES:

    Capacity: 500 to 1000 kgs

    Max hook height: 3100 mm

    Min hook height: 500 mm

    Excellent functioning

    Low rolling resistance

    High load bearing strength

    Reverse base allows for easier lifting of loads

    Steel construction & trademark Ruger blue coating

    Needle type release valve permits pin-point control over lowering and holding of the heaviest or lightest loads